联系我们： 手动添加方式: 微信>添加朋友>企业微信联系人>13262280223 或者 QQ: 1483266981
这是一篇加拿大作业是一个C++嵌入式软件开发的assignment
The goal of this assignment is to develop and test a simulator for embedded software used in Cranial Electrical Stimulation (CES) devices similar to the Alpha-Stim and OasisPro products described below.
A CES device is a non-invasive neuro-stimulation medical device that delivers microcurrent via an electrode through the earlobes to stimulate the brain for the purpose of therapeutic intervention. The implementation and testing are to be in C++ using the Qt framework on the COMP3004-F21 VM which has the Qt Creator IDE installed.
For purposes of this assignment you can assume a hardware layout similar to that of the AlphaStim presented below.

What needs to be simulated

ON/OFF switch
Continuous circuit check when electrodes are in contact with the skin indicated by a test circuit symbol that shows contact ON (connected) or OFF (disconnected). If skin contact is lost during treatment for less than 5 seconds treatment resumes, otherwise, treatment stops. Loss of skin contact is shown by the indicator changing from ON to OFF.
Three frequency options of 0.5Hz, 77Hz and 100Hz.
Three wave form options Alpha, Betta and Gamma.
20, 40 or 60 minute countdown cycles.
Large timer display. Treatment starts when electrodes touch skin.
0 – 500 μA (microampere) current control (1-10): 50 μA when incrementing and 100 μA when decrementing.
30 minute auto – off when not in use.
Battery charge indicator: device issues a warning at 5% charge and shuts down at 2% after issuing another warning.
Recording: user can choose to record a therapy and add to history of treatment. Assume only a single user. Therapy information to be recorded: Waveform, frequency, start time, duration and power level (if changed during therapy choose last selected power level).
Automatically and permanently disables itself should a single fault develop within the device causing the current to exceed 700 μA.