联系我们： 手动添加方式: 微信>添加朋友>企业微信联系人>13262280223 或者 QQ: 1483266981
这是一篇来自瑞典的关于多天线系统项目1的作业作业

1 Purpose
The purpose of this assignment is to investigate the capacity for difffferent MIMO confifigurations. Both ergodic and outage capacities, and the difffference between the two, will be studied.
2 Channel Normalization
1 Since channel capacity depends on the receive signal-to-noise ratio (SNR), it is important to properly normalize the measured channel matrices for correct interpretation of the results. For channel matrices H(n), 1 ≤ n ≤ N, where N stands for the number of channel realizations, normalized MIMO channel matrices can be computed as
H(n)norm= H(n) [NM 1TMRNnX=1||H(n) ||2F#]1/2,
where ||·||F is the Frobenius norm, MT and MR denotes the number of transmitting and receiving antennas,respectively. Note that,

By setting N = 1, the difffferences in power levels among a number of channel matrices are removed through the normalization of each matrix independently.

Using N > 1, the relative power levels among the N difffferent channel realizations are preserved.

3 Tasks

Using the measured MIMO channel, “LOS 8 8.mat”, calculate the ergodic capacity for MT = MR =M = [1, 2, 4, 8] MIMO systems of difffferent SNRs. Calculate for both cases when channel knowledge is known and unknown to transmitter. Verify that, when the channel is known to the transmitter, the ergodic capacity is always higher than when it is unknown. Is this true at higher SNR Comment on the capacity gap between channel known and unknown to the transmitter with increasing M and SNR.

Plot the ergodic capacities without channel knowledge at transmitter, for the i.i.d. channel Hw of SNR ranging from 0 to 25 dB for the following antenna confifigurations:

(a) MT = MR = 1; (SISO)
(b) MT = 2;MR = 1; (MISO)
(c) MT = 1;MR = 2; (SIMO)
(d) MT = MR = 2; (MIMO)
(e) MT = MR = 4; (MIMO)

Comment with specifific reasoning on the relative values of the capacities. How does the MIMO system achieve a linear increase in capacity with the number of antennas M comparing to SISO system Do you observe higher capacity in SIMO system than in SISO system Why or why not

How about MISO system

Plot the probability distribution (CDF) curve of the 2 × 2 MIMO capacity. Defifine the ergodic and outage capacity on the graph.

Plot the 1% and 10% outage capacities instead of ergodic capacities for each of the antenna confifigurations specifified in previous task over the same SNR range. Verify that the outage capacity increases with SNR and is higher for a larger number of antennas.

4 Report
Write a short report. In order to pass, you should (1) describe the methods you apply to solve the problem,(2) present the results, e.g., in readable fifigures, and (3) comment on the results (important!). Computer code can be included as an attachment.